FAQ Routers

To get into a Connected IO Router, you need to do three things.

1. Prep your PC by configuring a physical Ethernet port to an address of 192.168.71.X, where X is any number from 2 to 254.

2.  Attach an Ethernet cable between the Router and your PC’s Ethernet port and power up the Router. (run: ping 192.168.71.1  command to make sure router replied)

3. Open a browser and type http://192.168.71.1 in the address bar. You should see the Login screen appear in your Browser. Type a default user name root and default password from the quickstart guide.

If you do not, Consult the User Guide for troubleshooting steps.

Click here to see a video:

1. Please select a device from the list you want to upgrade

2. Click on the Settings menu, and select upgrade:

3. Select version to upgrade to from the drop-down list:

4. Select  checkbox next to the device you want to start to upgrade

5. Select required conditions ( save the configuration or do factory restore etc) and start the upgrade.

From Cloud Portal:https://cloud.connectedio.com/

1. Go to the device configuration page, and open a WiFi tab:

2 Click Edit icon and edit SSID name, and click save icon:

3. Keep in mind update may require device module restart( may take a few seconds)

The default IP of the ER1000 is 192.168.45.1 the default IP of the ER2000 & CR48 series is 192.168.71.1. 
The default username is "root" and the password is based on the model:

ER1000:  CioER1000!

ER2500:  CioER2500!

CR48NA: cio@123$

Unlike previous versions of the Windows operating system, Windows 8 imposes strict limitations on driver signing. Because of this, unsigned drivers require extra steps for installation.

What to do:

1.Open Device page

2. Click on Quick Action menu to add the device

Complete the required fields and click save.

You can check the video:

CR48 XX:

WiFi password for 2.4 Ghz module: “ciotech123!”

WiFi password for 5.0  Ghz module: “ciotech12345!”

Default WiFi SSIDs: CIO-M2M and CIO-M2M-5Ghz

ER2000 and ER2500:

1. SSID: ConnectedIO_M2M
2. Password: CIO-last_6_digits_of_LAN_MAC  (no colon)

1 To set SIM Fail-Over configuration you need to have installed 2 SIM cards and all cards need to be activated

2. Switch for default card will be enabled only if 2 cards active

3. Admin can use a 1-time update or daily

4. Need to refresh device to get latest settings activated

Please check the video :

1. Open device management page:

2. Click on the Setting menu and select configure

3. Click on any Modules Tab you want to manage/change

4 Click save when you done with configurations

**** At some modules required device restart or router needs to be rebooted (it may take 30sec to 1 min)

How to update APN information:

Update using an APN change module from Cloud Portal:

1. Go to device management page and select config option from Settings menu

When clicking on the LTE TAB you'' be able to change /add new APN

Add new APN info and click Save, Make sure new APN switched to active